Today's project is to assemble the shot graphite powder tumbler. I finished getting all the parts needed to make my tumbler. New bucket, round 3/8" cast floor flange, bolts nuts and washers to secure the flange to the bucket bottom. 3" nipple to go in flange to attach to the motor shaft with a section of new heater hose and clamps. Four 2" rigid casters for the home Depot bucket to rotate on. I still need to wire up the motor (done), screw some 2x1 Short furring strips into my red harbor freight bucket to act as paddles and we're ready to go. Video link below. Test run to see if it works.

[Linked Image]

https://youtu.be/lFYCbFpZBvQ?si=18pKRc_0AJuDa4jh

Last edited by nitroexpress; 10/27/24 07:42 AM.